Seite 1 von 1
Moisture Load air Change
Verfasst: 24 Jun 2025, 21:17
von BerimaAdansePipim
Hello
I am trying to simulate a bathroom wall to measure its resistance to steam. how do I model moisture load (steam) due to air exchange.
Any videos. or guidance
Regards
Re: Moisture Load air Change
Verfasst: 25 Jun 2025, 09:56
von fechner
Hello,
You can have a look into the lightweight wall tutorial.
https://bauklimatik-dresden.de/delphin/ ... _air_space
Re: Moisture Load air Change
Verfasst: 26 Jun 2025, 20:35
von BerimaAdansePipim
Thank you for Sharing.
Thanks
Re: Moisture Load air Change
Verfasst: 28 Jun 2025, 23:55
von BerimaAdansePipim
Hi
Thank you for the other resource; it's was very helpful, but I am trying to model a bathroom wall exposed to steam from bathing in hot water from the shower. I tried something, but I am not quite sure. Any leads or articles to guide the model? I want to assess the resistance of a particular drywall to STEAM (hot water vapor from showers at a temperature of 50 degrees and water pressure of about 240 Pa).
Thank you.
Re: Moisture Load air Change
Verfasst: 30 Jun 2025, 10:41
von fechner
This sounds like a own boundary condition for the inner side.
You can switch the type of the interface for inside to the detailed model. Here you can set your own climate data for temperature and relative humidity.